` Changed areawarp script command to accept two additional, yet optional, parameters to allow an area warp to an area (instead of just a specific coordinates). See documentation.

git-svn-id: https://rathena.svn.sourceforge.net/svnroot/rathena/trunk@16636 54d463be-8e91-2dee-dedb-b68131a5f0ec

1 files changed, 6 insertions, 1 deletions

diff --git a/doc/script_commands.txt b/doc/script_commands.txt
index e3949afde..f63288da1 100644
--- a/doc/script_commands.txt
+++ b/doc/script_commands.txt
@@ -3701,7 +3701,7 @@ There are also three special 'map names' you can use.
 
 ---------------------------------------
 
-*areawarp "<from map name>",<x1>,<y1>,<x2>,<y2>,"<to map name>",<x3>,<y3>;
+*areawarp "<from map name>",<x1>,<y1>,<x2>,<y2>,"<to map name>",<x3>,<y3>{,<x4>,<y4>};
 
 This command is similar to 'warp', however, it will not refer to the invoking 
 character, but instead, all characters within a specified area, defined by the 
@@ -3719,6 +3719,11 @@ Y 150
 By using ,0,0; as the destination coordinates it will take all the characters in 
 the affected area to a random set of co-ordinates on "place2".
 
+	areawarp "place",10,10,120,120,"place2",150,150,200,200;
+
+By using the optional x4 and y4 parameters, the destination coordinates will be a 
+random place within the defined x3/y3-x4/y4 square.
+
 Like 'warp', areawarp will also explicitly warp characters randomly into the 
 current map if you give the 'to map name' as "Random".